You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close
You are viewing the article in preview mode. It is not live at the moment.
02 - Reset my Bluetooth lamp
print icon

⚠ : This procedure is only possible with Bluetooth Mesh lamps.

(Bulbs, Panels, Ceilings, StripLED ... AwoX and EGLO)

 

  • First, remove your lamp from the application by long press on its icon and then use the trash can.

 

  • Then perform the electrical reset factory process on your lamp using a switch :

 

  1. Start by switching off your lamp (about 10 seconds).
  2. ON: (Turn on the lamp) less than a second
  3. OFF : (Turn off the lamp) 6 seconds
  4. ON : < 1 sec
  5. OFF : 6 secs
  6. ON : < 1 sec
  7. OFF : 6 secs
  8. ON : 12 secs
  9. OFF : 6 secs
  10. ON : 12 secs
  11. OFF : 6 secs
  12. ON : Lamp flashes, then turns red

 

  • Once the reset is done (lamp in red), add the lamp to the application with the "+" button from the "My Devices" screen.

 

Feedback
147 out of 403 found this helpful

scroll to top icon